Toyota VELLFIRE 2010 Manual page 288

Machine Translated by Google
286 4-5. Driving support equipment
ÿ Sensing of obstacles in the side area
(vehicles equipped with Intelligent Parking Assist 2)
Obstacles in the side area are not directly detected by sensors, but are detected by front
and rear side sensors before calculating the vehicle's position. to calculate the
position of the obstacle. Therefore, even if there is an obstacle in the side area, it may
not be detected until the sensor scans the side area after driving for a while after
turning the power switch to ON mode.
•When a vehicle, person, animal, etc. is detected by the side sensor, the detection
continues even if the vehicle, person, animal, etc. leaves the detection range of the side sensor.
•While scanning the side area, the display on the multi-information display is
It will be as follows.
When scanning is complete, the multi-information display continues for about 3
seconds, and then the sensor operation indicator turns off.
when moving forward
Multi-
information
display
display
Vehicle condition*
: Sensing area of side sensor :
Side area (area where side area scanning is not completed) :
Side area (area where side area scanning is completed)
*
The illustration is an example for explanation and differs from the actual sensing area.
Scanning of
the side
area is incomplete
power switch
Immediately after switching to ON mode
Completed
scanning of
the front half of the vehicle
The state in which the vehicle has moved
forward half the total length of the vehicle.
Side area
scanning
completed
The state in which the vehicle has moved
forward for the full length of the vehicle.