Toyota VELLFIRE 2010 Manual page 244

Machine Translated by Google
242 4-3. How to turn on the lamp and how to use the wiper
Cornering lampÿ
When any of the following conditions are met when the headlamps (low beam) are turned
on, the cornering lamps are additionally turned on to illuminate the direction in which the
vehicle is traveling in order to ensure excellent visibility at intersections and
when parking at night. • When the
steering wheel is operated • When the
direction indicator lever is operated • When the shift lever is in R (both left and right
cornering lamps light up) However, when the vehicle speed is about 40km/h or more, the
cornering lamps do not light up.
knowledge
ÿLED daylightÿ
When driving in the daytime, after starting the hybrid system, release the parking brake and turn the
lamp switch to make it easier for other drivers to see your vehicle.
The LED daylights automatically turn on (lights brighter than the side lights).
LED daylights are not intended for nighttime use.
ÿ Light sensor
Do not place anything on the sensor or stick anything
on the front windshield that may block the sensor. If
the light from the surroundings is blocked, the automatic
turn on/off function will not work properly.
ÿ Function to prevent forgetting to turn off the lamp
If you open the front door or sliding door with the power switch set to accessory mode or OFF with
the lamps on, the headlamps and taillights will automatically turn off. To turn on the lamp again, set
the power
switch to ON mode or turn off the lamp once.
switch to the or position, and then to the or position again.
vinegar.
ÿ: Equipment may or may not be available depending on the grade and options.