Toyota VELLFIRE 2010 Manual page 249

Machine Translated by Google
•In the following situations, the surrounding brightness may not be detected accurately, and the
high beam may become a nuisance to oncoming or preceding vehicles, or the low beam may
continue. In such cases, manually switch between high beam and low beam.
ÿ Bad weather (fog, snow, sandstorm,
heavy rain, etc.) ÿ When the windshield is dirty or cloudy ÿ When the
windshield is cracked or damaged ÿ The inner mirror or
camera sensor is deformed•When there is light similar to a headlamp or
taillight in the surrounding area •When the oncoming
or preceding vehicle has no lights, or when the lights are dirty or discolored.
or the optical axis is
deviated •When the brightness
changes rapidly •When driving on a road with
many ups and downs or steps •When
driving on a road with many curves •When there are signs or mirrors in
front of the vehicle When there is an object that strongly
reflects light, such as a container ÿ When the rear of
the preceding vehicle reflects light strongly ÿ When
your vehicle's headlights are damaged or dirty When the multi-information display
shows the warning message "Headlamp system failure. Please check at your dealer."
ÿ On the multi-information display, "Headlamp system failure at the dealer.
If the warning message "Please check" is displayed, there
may be a problem with the system. Have it checked at a Toyota dealer.
caveat
ÿ For safe use
Don't rely on automatic high beams. It is the driver's responsibility to always be
aware of their surroundings, drive safely, and switch between high beam and low
beam manually as necessary.
4-3. How to turn on the lamp and how to use the wiper
247
4 driving