SYSTem:BEEPer:STATe <state>
SYSTem:BEEPer:STATe?
Parameters
Returned Data
Comments
Error Conditions
Reset Condition
Related
Commands
Chapter 3
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
SYSTem:BEEPer:STATe
SYSTem:BEEPer:STATe?
If ON, the beeper will beep for key presses, during internal self test execution, and
when a warning condition occurs in the mainframe. If OFF, a beep will not occur
unless the
SYSTem:BEEP
Name
Type
<state>
Boolean
Type
Range
Boolean 0, 1
Beeper state. 0 is off, 1 is on.
•
The S
YSTem:BEEP:STATe OFF
occurring if a
SYSTem:BEEP
The following table lists the most common error conditions and causes. Error
numbers and corresponding messages can be found using
Number
Message
-221
"Settings Conflict"
*RST sets the state to ON.
SYSTem:BEEPer:STATe?
<state> sets the state of the beeper.
returns an integer with the state of the beeper.
command is issued.
Range
Default
ON, OFF, 0, 1
ON
Description
command does not prevent a beep from
is sent.
The mainframe's power is off.
Programming the Enhanced Monitor
Description
State of beep warning.
0 is off, 1 is on.
query.
SYSTem:ERRor?
Probable Cause
129