Replacing the
Enhanced Monitor
Controller Board
Pull Ring
Enhanced Monitor
Controller Board
Figure 5-4. Removing/Replacing the Enhanced Monitor Controller Board
Chapter 5
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
1. Turn off the mainframe and remove the power cord.
2. Remove the rear panel. Refer to "Removing the Rear Panel from the
Mainframe" on page 209 for instructions.
3. Grasp the pull ring on the Enhanced Monitor PC Board and gently
pull it from the mainframe.
4. To replace the board, align the board in the card guides. slide the
board forward and press it into the backplane connectors.
Getting Started 213