Rack Mounting The Agilent E840Xa Using Rack Slide Rails; Procedure - Agilent Technologies VXI 75000 Series User And Service Manual

WARNING
Rack Mounting the
Agilent E840xA
Using Rack Slide
Rails

Procedure

Appendix B
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
6. Remove the mainframe feet by lifting the tabs and sliding the feet
towards the center of the mainframe.
7. With one person on each side of the mainframe, lift the mainframe
onto the support rails. Slide the mainframe into the rack until the rack
mount adapter flanges are against the rack's vertical rails. Secure the
mainframe to the rack using the adapter dress screws.
To prevent injury during rack mounting, the mainframe should
be empty and two people should lift the mainframe into the
rack.
This section contains instructions for mounting the Agilent E840xA
mainframe in an EIA cabinet using the rack slide kit (p/n 1494-0411). The
rack slide kit, which is used with either the Standard adapters (Option 923)
or the VXIplug&play Compliant adapters (Option 925), allows you to
extend the mainframe from the cabinet for easier access to installed
instruments.
The following procedures apply to the adapter kits listed above, with
adapter-specific information noted where necessary. The rack slide kit is not
used with the flush mount adapters (Option 924).
1. Attach the handles to the standard adapters using the m5x10 flat head
screws (Figure B-5). Handles are included only with the Agilent
E840xA Standard adapters (Option 923).
Rack Mounting and Option Installation 239