History:current:cmaximum? <Supply - Agilent Technologies VXI 75000 Series User And Service Manual

HISTory:CURRent:CMAXimum? <supply>
Parameters
Returned Data
Comments
Error Conditions
Reset Condition
Related
Commands
Chapter 3
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
HISTory:CURRent:CMAXimum?
for the maximum amperage (in milliamps) measured by the Enhanced Monitor for
the <supply> since power-on of the mainframe.
Name Type Range
<supply> enum. P5, P12, N12, P24,
N24, N5PT2, N2
Type Range
float
•
These maximums can be reset by powering the mainframe off and then
powering it back on.
The following table lists the most common error conditions and causes. Error
numbers and corresponding messages can be found using
Number Message
-221 "Settings Conflict"
-224 "Illegal Parameter"
*RST has no effect on the HISTory subsystem.
HISTory:CURRent:MAXimum?, HISTory:CURRent:[HISTogram]?
<supply> returns a single floating point number
Default
none Selects the power supply for the
current maximum request. P5 is
positive 5 Vdc supply, N12 is negative
12 Vdc supply, etc.
Description
Maximum current (in amperes) for specified power supply.
Probable Cause
The power supply doesn't support current
measurements.
The <supply> parameter was not correct.
Programming the Enhanced Monitor
Description
query.
SYSTem:ERRor?
65