Status:operation:event - Agilent Technologies VXI 75000 Series User And Service Manual

STATus:OPERation:EVENt?

Returned Data
Comments
Reset Condition
Related
Commands
Chapter 3
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
The
STATus:OPERation:EVENt?
the event register for the operation status group.
The event register latches positive transition events from the condition register. A
positive transition event will occur when a condition makes a transition from a low
to a high state. Bits in the event register are latched, and once set, they remain set
until cleared by a
STATus:OPERation:EVENt?
is no buffering; so while an event bit is set, subsequent events corresponding to that
bit are ignored. Event registers are read only.
Events are queried in order to determine if transitions have occurred since the last
query. They do not indicate the current state (condition) of a particular event. Nor do
they indicate how many times a transition has occurred.
Type Range Default
int16 0 - 32767 none
•
Refer to
STATus:OPERation:CONDition?
OPERation status group.
•
Cleared by: *CLS, power-on, and by reading the register.
*RST does not affect the status system, use *CLS to clear all event registers.
STATus:OPERation:CONDition?, STATus:OPERation:ENABle,*CLS
query returns an integer representing the value of
query or *CLS (clear status). There
Description
Bit mask indicating which events are set (1) or cleared (0) for
the OPERation status group. Each event has a decimal
weighted value.
for a description of each bit in the
Programming the Enhanced Monitor 93