System:beeper[:Immediate] [<Frequency>[,<Duration>]] - Agilent Technologies VXI 75000 Series User And Service Manual

SYSTem:BEEPer[:IMMediate] [<frequency>[,<duration>]]
Parameters
Comments
Error Conditions
Reset Condition
Related
Commands
128 Programming the Enhanced Monitor
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
SYSTem:BEEPer[:IMMediate]
parameters <frequency> and <duration> override the frequency and time settings
set by
SYSTem:BEEP:FREQ
Name Type Range
<frequency> int16 125 - 6000
MIN, MAX
<duration> float32 0.01 - 2.0
MIN, MAX
•
The mainframe will beep whether
•
Out of range values for <frequency> and <duration> do not cause the
mainframe to generate an error. Instead, the closest minimum or maximum
value is used, and the beeper sounds. For example, if you specify <frequency>
as 10000, it is clamped at 6000. Similarly, if you specify 100, it is clamped at
125.
The following table lists the most common error conditions and causes. Error
numbers and corresponding messages can be found using
Number Message
-221 "Settings Conflict"
*RST has no effect on the
SYSTem:BEEPer:FREQuency, SYSTem:BEEPer:TIME
causes the mainframe to beep. The optional
and
SYSTem:BEEP:TIME
Default
1000 Frequency of beep, in Hertz
0.2 Duration of beep, in seconds
SYSTem:BEEP:STATe
The mainframe's power is off.
command.
SYSTem:BEEP
.
Description
is ON or OFF.
query.
SYSTem:ERRor?
Probable Cause
Chapter 3