Status:operation:enable <Mask> Status:operation:enable - Agilent Technologies VXI 75000 Series User And Service Manual

STATus:OPERation:ENABle <mask>
STATus:OPERation:ENABle?
Parameters
Returned Data
Comments
Error Conditions
Reset Condition
Related
Commands
92 Programming the Enhanced Monitor
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
The
STATus:OPERation:ENABle
the operation status group.
The
STATus:OPERation:ENABle?
the enable register for the operation status group.
The enable register specifies which bits in the event register can generate a summary
bit. The instrument logically ANDs corresponding bits in the event and enable
registers, and ORs all the resulting bits to obtain a summary bit. The operation status
summary bit is recorded in the Status Byte. Enable registers are read-write. Enable
registers are not affected by *CLS (Clear status). Querying enable registers does not
affect them.
Name Type Range
<mask> int16 0 - 32767
Type Range
int16 0 - 32767 mask value.
•
Refer to
STATus:OPERation:CONDition?
OPERation status group.
•
To enable a bit in the event register, specify that bit's decimal value as the
<mask> parameter. To enable two or more bits, specify the sum of the decimal
values.
•
The <mask> parameter may be sent as a decimal, hexadecimal (#H), octal
(#Q), or binary (#B) number.
•
The Enable register values are saved in non-volatile RAM with the
command. The register values are restored to the registers at
SYSTem:NVSave
power-on if *PSC was set to 0 before power-on.
restore the enable registers.
The following table lists the most common error conditions and causes. Error
numbers and corresponding messages can be found using
Number Message
-222 "Data out of range"
*RST resets register the last value saved by the SYST:NVS command. Use
to clear the enable registers of the OPERation status group and the
STATus:PRESet
QUEStionable status group.
STATus:OPERation:CONDition?, STATus:OPERation:EVENt?, STATus:PRESet,
SYSTem:NVSave, *PSC
command sets the value of the enable register for
query returns an integer representing the value of
Default
none Bit mask for the enable register of the
(see last OPERation status group. Each operation
comment) enable bit has a decimal weighted value.
Description
for a description of each bit in the
SYSTem:NVRecall
Probable Cause
The <mask> was an invalid number (for example, it
may be negative).
Description
will also
query.
SYSTem:ERRor?
Chapter 3