Status:questionable:enable <Mask> Status:questionable:enable - Agilent Technologies VXI 75000 Series User And Service Manual

STATus:QUEStionable:ENABle <mask>
STATus:QUEStionable:ENABle?
Parameters
Returned Data
Comments
Error Conditions
Reset Condition
Related
Commands
106 Programming the Enhanced Monitor
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
The
STATus:QUEStionable:ENABle
for the questionable status group.
The
STATus:QUEStionable:ENABle?
of the enable register for the questionable status group.
The enable register specifies which bits in the event register can generate a summary
bit. The instrument logically ANDs corresponding bits in the event and enable
registers, and ORs all the resulting bits to obtain a summary bit. Summary bits are,
in turn, recorded in another register. The questionable status summary bit is recorded
in the Status Byte. Enable registers are read-write. Enable registers are not affected
by *CLS (Clear status). Querying enable registers does not affect them.
Name Type Range
<mask> int16 0 - 32767
Type Range
int16 0 - 32767 mask value.
•
Refer to
STATus:QUEStionable:CONDition?
QUEStionable status group.
•
If *PSC was set to 0 prior to power-down, then at power-on, the enable
registers are loaded from non-volatile memory. Therefore, any values that you
have stored (SYSTem:NVSave command) are returned to the registers.
However, if *PSC was set to 1, then at power-on the factory defaults are
returned.
The following table lists the most common error conditions and causes. Error
numbers and corresponding messages can be found using
Number Message
-222 "Data out of range"
*RST resets register the last value saved by the SYST:NVS command. Use
to clear the enable registers of the OPERation status group and the
STATus:PRESet
QUEStionable status group.
STATus:QUEStionable:CONDition?, STATus:QUEStionable:EVENt?,
STATus:PRESet, SYSTem:NVSave, *PSC
command sets the value of the enable register
query returns an integer representing the value
Default
0 Bit mask for the enable register of the
(see 2nd QUEStionable status group.
comment below)
Description
for a description of each bit in the
Probable Cause
The <mask> value is invalid.
Description
query.
SYSTem:ERRor?
Chapter 3