4 Turn on the emulation probe power switch.
Connection Sequence
Disconnect power from the target system, emulation probe, and logic analyzer
before you make or break connections.
1 Connect the emulation probe to a LAN (page 37).
2 Connect the emulation probe to your target system (page 59).
3 Configure the emulation probe (page 69).
To power on the system
With all components connected, power on your system as follows:
1 Logic analyzer, if you are using one.
2 Emulation probe.
3 Your target system.
To power off the system
Power off your system as follows:
1 Your target system.
2 Emulation probe.
3 Logic analyzer, if you are using one.
Agilent Technologies Emulation for the PowerPC 400/600/700
To connect the emulation probe to a power source
Chapter 1: Overview
23