Miele G500 Technical Information page 82

Technical Information
4.1.6 Program Sequence
A program consists of two basic elements:
Main program
Optional functions
Each program is compiled from the following list of program steps:
Pre-rinse
Main wash
Interim rinse
Final rinse
Drying
As soon as a program step has been completed, the corresponding LED
goes out.
Once the selection of a program is complete, the display shows the
remaining program duration. The time is counted down so that the
remaining program length is displayed at any given time.
If the "Pre-selection 1-9 hrs" is selected, the amount of time remaining
before the desired program is due to begin is counted down.
Once selected, a program can only be cancelled by pressing the ON/OFF
switch and thus activating the auxiliary contact. Data relevant to a
selected program is stored when the door is opened and in the event of a
mains failure.
4.1.7 Fault Monitoring Functions
The following functions are monitored by the microprocessor:
Drainage and water inlet system
Mains failure, temperature controls, program durations, heating water
levels
Note:
Two dashes appear in the digital display to indicate a fault in the
electronic controls. In this event, a fault code can be displayed in the
Service Program.
'
82
G500 Dishwashers