Miele G500 Technical Information page 30

Technical Information
2.1.2 Alterations to the Plinth Height
Remove the décor panel as described in Section 2.1.1.
Refer to Figure 2-3 – Alterations to the Plinth Height. Unfasten the
screws holding the adapter in place (Item 1) and adjust the adapter (Item
2) so that it is flush with the lower edge of the adjacent units and screw
tightly in place.
The plinth height is freely adjustable between 10 and 17 cm.
Note:
The cardboard spacer is no longer needed once alterations have been
made to the plinth height.
Cut back the décor panel according to the table to correspond to the new
plinth height. Fit the panel and saw off the side décor frame strips at the
bottom at the required height. Fit the strips and screw tightly in place.
Figure 2-3: Alterations to the Plinth Height
Note:
The thickness of the décor panels used should not exceed 1.5 mm.
30
G500 Dishwashers