Miele G500 Technical Information page 114

Technical Information
6.1.1.4 Re-Programming Additional Functions
Important!
Make a note of the additional functions already programmed in when
called out to service a machine. If the electronic unit has to be replaced,
the additional functions will have to be re-programmed (unless the
selected options are no longer applicable or necessary).
Any alterations to the heater rating (5 + 6) must correspond to the
machine and the available power supply. Check by referring to the
section on connection to the electricity supply in the operating
instructions. By altering the heating setting, the heater rating is not
increased; the program times allocated to heating up water are altered to
suit the heater rating!
If water consumption is increased by altering an option, a higher water
hardness setting should be set at the selector in the cabinet.
Figure 6-3: Re-Programming Additional Functions
1. Switch the dishwasher off.
2. Enter the programming mode by pressing "Short 45°" and "Without
drying" together, and at the same time switch the machine on again.
3. Select the desired option (1 – 8). The number of the selected function
will then appear in the display.
4. Press "Without drying" to alter the status from 0 to 1 or vice versa.
5. Press "Pre-selection 1-9 hrs".
The letters "SP" appear in the display.
6. Press "Pre-selection 1-9 hrs" a second time to acknowledge the
selected option.
114
G500 Dishwashers