Miele G500 Technical Information page 36

Technical Information
2.2.6 Adjusting the Plinth Recess
Figure 2-8: Adjusting the Plinth Recess
On built-under models, the plinth recess can be infinitely adjusted
between 35 and 100 mm (refer to Figure 2-4 – Installation Measurements,
Item 1).
1. Unfasten the bracket (refer to Figure 5-8 – Adjusting the Plinth
Recess, Item 1) – adjust to the desired depth and tighten.
2. Fit the plinth strip supplied (Item 2). Refer to Section 2.2.6.1 –
Alterations to the Height of the Plinth Strip.
Note:
The plinth strip supplied with the machine is not required if the
dishwasher is installed in a run of kitchen furniture with a continuous
plinth strip. Refer to Section 2.2.8 – Fitting a Continuous Plinth Strip.
36
G500 Dishwashers