Miele G500 Technical Information page 103

G500 Dishwashers
10. Place the motor (Figure 5-10, Item 1) on its housing (Figure 5-10, Item
2) and insert the special device (Figure 5-10, Item 4) into the center of
the housing from the bottom and place the complete unit on a flat
surface (Figure 5-10, Item 5). Fit all screws and remove the centering
device. Fit the seal (Figure 5-10, Item 6) and carefully press the
impeller (Figure 5-10, Item 7) onto the motor shaft.
11. Fit the fan unit onto the inner door panel as follows:
a) Fit the seal (Figure 5-10, Item 3) into the fan housing (Figure 5-10,
Item 2).
b) The cap (Figure 5-8, Item 4) can only be screwed in place in one
direction. The slot near the rim (Figure 5-8, Item 5) should point
downwards.
12. Replace all removed parts and carry out a test run.
103
Technical Information