Miele G500 Technical Information page 71

G500 Dishwashers
3.2.3.6 Program Sequence Display
Once a program has been selected, the following information is
displayed:
1. The length of the current program in minutes.
The display automatically counts down as the program progresses
and shows the duration of the remaining section of the program at any
given time (residual time display). If the "Pre-selection 1-9 hrs"
function has been chosen, an hourly count-down takes place until the
program is due to start.
2. LEDs show the stage a program has reached at any given time. Once
a step has been completed, the corresponding lamp goes out. The
complete program has finished when all the LEDs have gone out and
a "0" appears in the display.
If the door is not opened at this point, the drying fan continues to
operate for a few minutes to remove excess steam from the cabinet.
3.2.3.7 Inlet and Drainage Control Lights
Two further LEDs give additional information in the event of a fault
occurrence:
1. Water inlet: This LED begins to flash within a matter of minutes if the
stopcock has not been turned on. A "0" appears in the display.
2. Drainage: This LED begins to flash within a matter of minutes if water
fails to be pumped out of the machine (refer to Section 3.2.5.3 –
Cleaning the Drain Pump and Non-Return Valve).
71
Technical Information