Miele G500 Technical Information page 39

G500 Dishwashers
Technical Information
Figure 2-11: Using Brackets to Secure the Dishwasher
Insert the short leg of the bracket into the hole, push the dishwasher into
place, fit the sponge rubber and secure the dishwasher using 3.9 x 22
mm screws.
2.2.8 Fitting a Continuous Plinth Strip
Problems may be caused in the case of continuous plinth strips which are
either too high or have an insufficient plinth return when the dishwasher
door is fully opened.
To prevent the occurrence of this type of problem, the continuous plinth
strip must be cut out in the area along the front of the dishwasher as
shown in Figure 2-12 – Continuous Plinth Strip, Item 1.
Figure 2-12: Continuous Plinth Strip
39