8
Replacing the fuse (AC system only)
The fuse is located below the power input socket on the rear panel. When
the server fuse blows, the server stops operating.
Requirements
You require the following:
•
•
To replace the fuse
Step
1
2
3
4
Copyright © 2007, Nortel Networks
.
Tighten the module thumbscrew and replace the front bezel.
CAUTION
Risk of equipment damage and personal injury
Disconnect power from the server before replacing a fuse.
an approved fuse for replacement
Two different types of fuses exist: one for North America, and one for
international use. Ensure that the fuse you are replacing has been
approved by Nortel for your region.
a flat-blade screwdriver
Action
Power off the server.
Unplug the power cable from the wall outlet.
Unplug the power cable from the power input socket on the server.
Unscrew the fuse receptacle (see A in
Nortel CallPilot
1002rp Server Maintenance and Diagnostics
NN44200-701 01.02 Standard
5.0 4 April 2007
Replacing the fuse (AC system only) 91
—End—
"Fuse receptacle" (page
92)).
Nortel Networks Confidential