Nortel CallPilot User Manual page 117

To configure an LSI Elite 1600 or LSI320-2 RAID system
Step
1
2
3
4
5
6
7
8
9
Copyright © 2007, Nortel Networks
.
Configuring the RAID controller after a hardware change 117
Action
Turn on the server and press Ctrl+M when prompted during system
bootup.
Note: The Ctrl+M utility can take up to 1 minute to launch. The
system may appear frozen. Do not reset.
From the Management menu, select Objects and press Enter.
From the Objects menu select Adapter and press Enter.
From the Adapter menu select Factory Default.
Select Yes to confirm the selection and press Enter.
Press Ctrl+Alt+Delete when prompted to restart system.
During bootup, press Ctrl+M to re-enter the RAID setup utility.
From the Management menu select Objects → Adapter, then ensure
the values are set as follows:
Flex RAID Power Fail: Enabled
Fast Initialization: On
Disk Spin up Timing: 1 Disk every 6 secs
Cache Flush Timings: Every 4 seconds
Rebuild Rate: 30%
Alarm Control: Enabled
Other Adapter Settings:
— Emulation: Mass Storage
— Auto Rebuild: Disabled
— Initiator ID: 7
— Cluster Mode: Disabled
— Multiple PCI Delayed Transactions: Disabled
— Force Boot: On
— Coercion Algorithm: GigaByte Way
— Cc Restoration: Enabled
Note: The Coercion Algorithm must be set properly. Once
changed, it cannot be changed again. The only way to reset
it is to reconfigure RAID from scratch and load the default
configuration, then reboot.
Select Objects → Channel and press Enter. Ensure that the values
are set as follows:
Termination State: Enabled
Nortel CallPilot
1002rp Server Maintenance and Diagnostics
NN44200-701 01.02 Standard
5.0 4 April 2007
Nortel Networks Confidential