Nortel CallPilot User Manual page 134

134 Chapter 12 Replacing or adding voice processing boards
14
15
16
17
18
19
20
Copyright © 2007, Nortel Networks
.
Power up the server and log on to Windows.Result:The Windows
New Hardware Found Wizard screen appears.
Before clicking Next to install the hardware driver, wait 10 minutes or until
you see the dialog box "CallPilot is running and is able to accept calls";
otherwise the server could display a blue screen and then restart. If this
happens, the server may not recognize the cards or boards.
Click Next.
Select the presented Nortel MPB driver.
Repeat the previous two steps each time the Windows New
Hardware Found Wizard screen appears.
Restart the server
Note: After restarting the server, you receive a dialog box
indicating you have new hardware. Click OK.
Run the Configuration Wizard to detect the new hardware.
For instructions, refer to the Installation and Configuration Task List
(NN44200-306).
Result: The MPB96 board replacement is complete.
Test the multimedia channels to ensure the new MPB96 board is
functioning properly.
Refer to "Testing the CallPilot installation" in the Installation and
Configuration Task List (NN44200-306).
Nortel CallPilot
1002rp Server Maintenance and Diagnostics
NN44200-701 01.02 Standard
5.0 4 April 2007
ATTENTION
—End—
Nortel Networks Confidential