Nortel CallPilot User Manual page 38

38 Chapter 5 Using serial port diagnostic tools
Services to stop for COM1 testing
•
Services to stop for COM2 testing
•
•
•
•
•
•
•
Net Stop command
Use the Net Stop command to stop a specified service on a serial port.
Net stop command syntax
The Net Stop command uses the following syntax:
net stop <service_name>
You must restart the services that you shut down through the Net Start command
after you run the diagnostic. For details, see
To invoke the Net Stop command from Windows
Step
1
2
Copyright © 2007, Nortel Networks
.
CAUTION
Risk of stopping call processing
By stopping the services on COM2, you stop call processing on
CallPilot.
Routing and Remote Access Service
CallPilot SLEE Service
CallPilot MWI Service
CallPilot Access Protocol Emulator
CallPilot Blue Call Router
CallPilot Call Channel Router
CallPilot Time Service
Routing and Remote Access Service
Action
Click Start → Programs → Accessories → Command Prompt.
Result: The Command Prompt window appears.
At the Command prompt, type net stop "service_name", and
then press Enter.
Example: Type net stop "Remote Access Server", and then
press Enter.
Note: The quotation marks are required, as in the example
above.
Nortel CallPilot
1002rp Server Maintenance and Diagnostics
NN44200-701 01.02 Standard
5.0 4 April 2007
ATTENTION
"Restarting services" (page 43).
Nortel Networks Confidential