Nortel CallPilot User Manual page 39

3
Service Control (SC) command
Use the Service Control command to stop a specified service on a serial
port.
Service Control command syntax
The Service Control command uses the following syntax:
sc <service_name>
You must restart the services that you shut down through the Service Control
command after you run the diagnostic. For details, see
(page
To invoke the Service Control command from Windows
Step
1
2
3
Copyright © 2007, Nortel Networks
.
Result: The system runs the Net Stop command utility.
Type Exit, and then press Enter to exit the Command Prompt
window.
43).
Action
Click Start → Programs → Accessories → Command Prompt.
Result: The Command Prompt window appears.
At the Command prompt, type sc stop "service_name", and
then press Enter.
Example: Type sc stop "Remote Access Server", and then
press Enter.
Note: The quotation marks are required, as in the example
above.
Result: The system runs the Service Control command utility.
Type Exit, and then press Enter to exit the Command Prompt
window.
Nortel CallPilot
1002rp Server Maintenance and Diagnostics
NN44200-701 01.02 Standard
5.0 4 April 2007
Shutting down services 39
—End—
ATTENTION
—End—
"Restarting services"
Nortel Networks Confidential