Replacing The Fuse (Ac System Only) - Nortel CallPilot 1002rp Installation And Configuration Manual

Replacing basic chassis components

Replacing the fuse (AC system only)

Introduction
The fuse is located below the power input socket on the rear panel. When the
server's fuse blows, the server stops operating.
.
Requirements
You require the following:
an approved fuse for replacement
Two different types of fuses exist: one for North America, and one for
international use. Ensure that the fuse you are replacing has been
approved by Nortel Networks for your region.
flat blade screwdriver
To replace the fuse
1 Power off the server.
2 Unplug the power cable from the wall outlet.
3 Unplug the power cable from the power input socket on the server.
134
CAUTION
Risk of equipment damage and personal injury
Disconnect power from the server before replacing a fuse.
Standard 1.0
CallPilot