Nortel CallPilot User Manual page 115

To replace the LSI1600 card with the LSI320-2 card.
Step
If your replacement RAID card has been previously used and holds an existing
configuration, the system will report a mismatch between the controller NVRAM
and Drive MetaData. The steps below will correct the mismatch.
1
2
3
4
5
6
7
8
9
Copyright © 2007, Nortel Networks
.
Action
WARNING
Nortel strongly recommends that you not perform low level
formatting. Performing low level formatting results in the drives
becoming unusable.
Power up the server and click Ctrl+M to enter the utility.
Select Objects → Adapter → Other Adapter to set the following:
a. Set Force Boot to On.
b. Set Auto-Rebuild to Disabled.
c. Select Objects → Channel and ensure channel speed is 160M.
((Default for LSI320 is 320M).
d. Repeat for all channels.
Exit the utility and reboot the server.
Set the server to boot from CD.
Insert the RAID Update Utility CD and reboot the server.
Result: The DOS boot menu appears.
Select Update LSI320-2 Firmware.
Result: The system will prompt twice to confirm you are upgrading
the firmware.
Answer Y to both questions.
Result:The system upgrades the firmware and asks you to reboot.
Allow the system to reboot to Windows 2003.
Insert the RAID Update Utility CD and unzip the RAIDUP.EXE file.
Result: A directory called RAIDUP is created on C:\ drive
Nortel CallPilot
1002rp Server Maintenance and Diagnostics
NN44200-701 01.02 Standard
5.0 4 April 2007
Replacing the LSI1600 card with LSI320-2 115
ATTENTION
Nortel Networks Confidential