Nortel CallPilot User Manual page 129

3
4
5
6
7
8
9
10
11
12
M1/CS 1000 switch connectivity
To configure one MPB96 board
Plug the MPB96 card in PCI slot 3.
To configure three MPB96 boards
Step
1
2
Copyright © 2007, Nortel Networks
.
a. Set the card SW100 ID rotary dial switch to 0.
b. Ensure that there are no termination jumpers installed on P700.
Plug the Intel D/480JCT-2T1 PCI card 1 in PCI slot 4.
On the second Intel D/480JCT-2T1 PCI card:
a. Set the card SW100 ID rotary dial switch to 1.
b. Ensure that there are no termination jumpers installed on P700.
Plug the Intel D/480JCT-2T1 PCI card 2 in PCI slot 5.
Plug the MPB96 card in PCI slot 6.
On the third Intel D/480JCT-2T1 PCI card:
a. Set the card SW100 ID rotary dial switch to 2.
b. Ensure that there are no termination jumpers installed on P700.
Plug the Intel D/480JCT-2T1 PCI card 3 in PCI slot 7.
On the fourth Intel D/480JCT-2T1 PCI card:
a. Set the card SW100 ID rotary dial switch to 3.
b. Ensure that there are no termination jumpers on P700 pins 3
and 4.
Plug the Intel D/480JCT-2T1 PCI card 4 in PCI slot 8.
Plug the MPB96 card in PCI slot 9.
Connect the 7 drop CT Bus cable to all MPB96 and T1 cards.
Ensure that the end connectors are connected to the end cards and
no connector is left dangling at any end of the cable.
Action
Plug the first MPB96 board in PCI slot 3.
Plug the second MPB96 board in PCI slot 6.
Nortel CallPilot
1002rp Server Maintenance and Diagnostics
NN44200-701 01.02 Standard
5.0 4 April 2007
Installing valid configurations 129
—End—
Nortel Networks Confidential