Replacing Or Adding Dual Inline Memory Modules - Nortel CallPilot User Manual

Step
1
2
3
4
5
6

Replacing or adding dual inline memory modules

The DIMMs are located on the SBC. The gold-plated edge connectors on
DIMMs are designed to plug into matching edge-connector slots. The
design allows you to add or remove these modules repeatedly without tools
or without causing damage. Install DIMMs on the SBC only.
Capacity
The base CallPilot has one 512-Mbyte DIMM installed in Bank 1. Another
512-Mbyte DIMM can be installed in Bank 2 for total memory of 1 Gbyte. No
other memory configurations are supported on this server.
Requirements
To add DIMMs to the card, you require the following:
•
•
Copyright © 2007, Nortel Networks
.
Action
CAUTION
Risk of data loss
Perform this procedure only if specifically instructed to do so by
your Nortel representative.
Restart the server, and then press Delete to enter Setup when
prompted.
Set the MPS 1.4 Support value to Disabled in the Chipset menu.
Press F9 to accept the other default values.
Press Enter when prompted to confirm this change.
Press F10 to save and exit the BIOS setup.
Restart the server.
Result: BIOS reconfiguration is completed.
an antistatic wrist strap
DIMMs with gold-plated edge connectors
Nortel CallPilot
1002rp Server Maintenance and Diagnostics
NN44200-701 01.02 Standard
5.0 4 April 2007
Replacing or adding dual inline memory modules 147
—End—
Nortel Networks Confidential