Nortel CallPilot User Manual page 133

To replace or add an MPB96 board
Step
1
2
3
4
5
6
7
8
9
10
11
12
13
Copyright © 2007, Nortel Networks
.
Action
Courtesy stop all CallPilot channels.
Power down the server and all peripheral devices.
Disconnect the following cables:
a. power cable
b. peripheral device cables
c. DS30X cables (Meridian 1 and Communication Server 1000 only)
d. CTbus cable (if present)
Remove the server cover.
For instructions on removing the server cover, see
front bezel and server cover" (page
Unpack the replacement MPB96 board.
Hold the MPB96 board by its top edge or upper corners and then
align it with the following:
• end-plate opening in the chassis (ensure that the tapered foot
of the board's retaining bracket fits into the slot in the expansion
slot frame)
•
PCI connector
Press the new MPB96 board firmly into its slot.
Secure the board using the retaining screw.
Reattach the CTbus cable. Refer to
(page 128)
Replace the server cover.
Replace the front bezel and lock it.
Reconnect the peripheral device and power cables.
Reconnect the DS30X cable to the faceplate of the MPB96 board.
Note: Ensure that a single-point ground reference is available
for all the power outlets serving the CallPilot server and its
peripherals. Before the CallPilot server installation, a qualified
electrician must implement the single-point ground reference
requirement between the power outlets of the CallPilot server
and the power outlets of the switch.
Nortel CallPilot
1002rp Server Maintenance and Diagnostics
NN44200-701 01.02 Standard
5.0 4 April 2007
Replacing an MPB96 board 133
"Removing the
77).
"Installing valid configurations"
Nortel Networks Confidential