Replacing Or Adding Dual Inline Memory Modules - Nortel CallPilot 1002rp Installation And Configuration Manual

Maintaining the Pentium III SBC card
Replacing or adding Dual Inline Memory
Modules
Introduction
The Dual Inline Memory Modules (DIMMs) are located on the SBC. The
gold-plated edge connectors on DIMMs are designed to plug into matching
edge-connector slots. The design allows you to add or remove these modules
repeatedly without tools or damage. Install DIMMs on the SBC only.
Capacity
The base CallPilot has one 512 Mbyte DIMM installed in Bank 1. Another
512 Mbyte DIMM can be installed in Bank 2 for total memory of 1 Gbyte.
No other memory configurations are supported on this server.
Requirements
To add DIMMs to the card, you require the following:
an antistatic wrist strap
DIMMs with gold-plated edge connectors
To add SDRAM DIMMs to the SBC card
1 Remove the SBC card from the server and lay it down on a flat surface.
Note: To remove old DIMMs, perform steps 2 to 4. To add new DIMMs,
go to step 5.
2 Push the DIMM release tab outwards at both sides of the DIMM to be
removed.
3 Hold the DIMM by its edges, being careful not to touch its components.
Remove the DIMM by lifting it away from its slot. Store it in an antistatic
package.
204
Standard 1.0
CallPilot