Config Spanningtree Port Bpdumigrationcheck; Config Spanningtree Port Mode; Show Spanningtree Bridge; Config Spanningtree Bridge Maxage - NETGEAR GSM7324 Reference Manual

7000 Series L3 Managed Switch Reference Manual for Software v1.0

config spanningtree port bpdumigrationcheck

This command forces the specified port to transmit RST or MST BPDUs. The port <slot.port> is
the desired switch port. To set the migration check for all ports with a single command, "all" can
be specified. Note that the forceversion parameter for the switch must be set to 802.1w or 802.1s.
Default
Format

config spanningtree port mode

This command sets the Administrative Switch Port State to a new value for the specified port. The
port <slot.port> is the desired switch port. To enable or disable all ports with a single command,
"all" can be specified. Note that only 4095 ports can be enabled.
Default
Format

show spanningtree bridge

This command displays spanning tree settings for the bridge.
Format
Bridge Priority
Bridge Identifier
Bridge Max Age
Bridge Hello Time
Bridge Forward Delay
Bridge Hold Time

config spanningtree bridge maxage

This command sets the Bridge Max Age parameter to a new value for the common and internal
spanning tree. The maxage <value> is in whole seconds within a range of 6 to 40, with the value
being less than or equal to "2 times (Bridge Forward Delay - 1)".
Default
7-52
disable
config spanningtree port bpdumigrationcheck
<slot.port/all> <enable/disable>
disable
config spanningtree port mode <slot.port/
all> <enable/disable>
show spanningtree bridge
Configured value.
TConfigured value.
Configured value.
Configured value.
Minimum time between transmission of Configuration Bridge
Protocol Data Units (BPDUs)
20
May 30, 2003 Beta Draft
Switching Commands