Installing And Removing The Panel-Mounted Usb Port Extension; Parts Name - Mitsubishi Electric GOT SIMPLE Series Operation Manual

7.10
Installing and Removing the Panel-Mounted USB
Port Extension
The panel-mounted USB port extension is a waterproof USB extension cable.
The cable is used to route the USB interface (Host) of the GOT rear face to the front side of the control panel.

Parts name

The following shows the part names of the panel-mounted USB port extension.
GT14-C10EXUSB-4S
Ferrite core
USB plug

Installing and removing the panel-mounted USB port extension

Installing and removing the panel-mounted USB port extension to/from the control
panel
Install or remove the panel-mounted USB port extension as follows with attention to the curve or twist of the waterproof cap,
seal, and nut.
Panel thickness
Seal
Install the waterproof cap to the panel-mounted USB port extension so that the control panel surface is IP67F-rated.
Overtightening or undertightening may disable the waterproof effect.
Tighten the waterproof cap properly when the cable is not used.
Cable
Seal
Model name label
Panel Cutting Dimensions
Nut
Waterproof
cap
7.10 Installing and Removing the Panel-Mounted USB Port Extension
Cap installation chart
Waterproof cap
Nut
19.4±0.1
(0.77±0.01)
Panel thickness:
2 to 4mm (0.08 to 0.16inch)
Specified torque range:
0.30 to 0.34N ・ ｍ
7 INSTALLATION AND REMOVAL
7
Unit: mm (inch)
83