Chapter 8 Wiring Of Power Supply Section - Mitsubishi Electric GOT SIMPLE Series Operation Manual

8
WIRING OF POWER SUPPLY SECTION
• Page 87 Wiring of External Power Supply
• Page 88 Power Supply Wiring to the GOT
• Page 89 Grounding
• Page 93 Wiring Inside and Outside the Control Panel
• Page 94 Attaching a Surge Suppressor to Control Equipment
Be sure to shut off all phases of the external power supply used by the system before wiring.
Failure to do so may result in an electric shock, product damage or malfunctions.
Make sure to ground the FG terminal of the GOT power supply section solely for the GOT (ground
resistance: 100 Ω or less, ground cable diameter: 1.6 mm or more).
Not doing so may cause an electric shock or malfunction.
Correctly wire the GOT power supply section after confirming the rated voltage and terminal
arrangement of the product.
Not doing so can cause a fire or failure.
Tighten the terminal screws of the GOT power supply section in the specified torque range.
Undertightening can cause a short circuit or malfunction.
Overtightening can cause a short circuit or malfunction due to the damage of the screws or the GOT.
Exercise care to avoid foreign matter such as chips and wire offcuts entering the GOT.
Not doing so can cause a fire, failure or malfunction.
Plug the communication cable into the connector to be connected, and tighten the mounting screws
and the terminal screws in the specified torque range.
Undertightening can cause a short circuit or malfunction.
Overtightening can cause a short circuit or malfunction due to the damage of the screws or unit.
This section describes wiring to the GOT power supply section.
For the connection to a controller, refer to the following manual.
GOT2000 Series Connection Manual For GT Works3 Version1 that covers the controller used
For external dimensions of connection cable, refer to the following.
Page 119 APPENDICES
WARNING
CAUTION
8 WIRING OF POWER SUPPLY SECTION
8
85