Mitsubishi Electric GOT SIMPLE Series Operation Manual page 5

[DESIGN PRECAUTIONS]
CAUTION
● Do not run the control line cables and communication cables together with or near the main circuit
cables, power line cables, or other cables.
Keep a distance of 100 mm or more between them as a guide.
Not doing so may cause a malfunction due to noise.
● Do not press the GOT display section with a pointed material as a pen or driver. Doing so can result in
a damage or failure of the display section.
● When the GOT connects to an Ethernet network, the IP address setting is restricted according to the
system configuration.
[GS25]
When a GS25 model and a GOT1000 series model are on an Ethernet network, do not set the IP
address 192.168.0.18 for the GOTs and the controllers on this network.
Doing so can cause IP address duplication at the GOT startup, adversely affecting the communication
of the device with the IP address 192.168.0.18.
The operation at IP address duplication depends on the devices and the system.
[GS21]
Setting the IP address (192.168.3.18) in the following system configurations can cause IP address
duplication at GOT startup, adversely affecting communications of the device whose IP address is
192.168.3.18.
The operation at IP address duplication depends on the devices and the system.
When multiple GOTs connect to the Ethernet network: Do not set the IP address (192.168.3.18) for
the GOTs and the controllers in the network.
When one GOT connects to the Ethernet network: Do not set the IP address (192.168.3.18) for the
controllers other than the GOT in the network.
● When using the Ethernet interfaces, set an IP address for each interface to access a different
network.
● Turn on the controllers and the network devices to be ready for communication before they
communicate with the GOT. Failure to do so can cause a communication error on the GOT.
● When the GOT is subject to shock or vibration, or some colors appear on the screen of the GOT, the
screen of the GOT might flicker.
3