Mitsubishi Electric GOT SIMPLE Series Operation Manual page 98

Writing package data
Write package data with GT Designer3 Version1.
The writing procedure differs depending on the data writing method.
Terms
• Basic software
The basic software is equivalent to an operating system of the GOT.
A GOT in which no basic software is written cannot be started.
• Package data
The package data contains project data and applications necessary to execute the project data.
Writing the package data into the GOT enables you to use the user-created project data on the GOT.
■Writing package data directly from a personal computer to the GOT
Connect the GOT and a personal computer, and write the package data to the GOT.
1.
Connect the personal computer with the GOT.
• USB
Connect the USB interface (Device) and the USB port of the personal computer with a USB cable.
• Ethernet
Connect the Ethernet interface and the Ethernet port of the personal computer with an Ethernet cable.
To write the package data to the GOT by Ethernet, install the basic software to the GOT and configure the communication
settings to enable the communication between the GOT and the personal computer by Ethernet in advance.
• Via PLC
Connect the GOT and a personal computer via the PLC connected to the GOT.
For each connection setting, refer to the following.
GT Designer3 (GOT2000) Screen Design Manual
2.
Turn on the GOT.
3.
Write the package data with GT Designer3 Version1.
For how to write the package data, refer to the following.
GT Designer3 (GOT2000) Screen Design Manual
■Writing package data from the data storage to the GOT
Write the package data to the GOT using the data storage such as an SD card.
1.
Install a data storage such as an SD card to the personal computer.
2.
Write the package data to the data storage with GT Designer3 Version1.
For how to write the package data, refer to the following.
GT Designer3 (GOT2000) Screen Design Manual
3.
Install the data storage to the GOT.
SD card (drive A): installed to the SD card interface
Data storage (drive B, E, F, or G): installed to the USB interface (Host)
4.
Turn on the GOT.
To start the GOT with the built-in flash memory (drive C), write the package data to the built-in flash memory (drive C) of the
GOT.
For how to write the package data, refer to the following.
GOT2000 Series User's Manual (Utility)
To start the GOT with the data storage (drive A, B, D to G), writing the package data to the built-in flash memory (drive C) of
the GOT is not required.
9 OPERATING THE GOT
96
9.1 Outline Procedure to Start the GOT