Mitsubishi Electric GOT SIMPLE Series Operation Manual page 54

No. Name
20) Ethernet communication status LED
21) RS-422/485 interface
22) RS-232 interface
23) Sound output interface
24) Rating plate
*1 When you remove the USB cable from the GOT, support it by hand after the successful completion dialog is displayed.
For closing the USB environmental protection cover, fix the cover to the GOT by firmly pushing the USB mark on the latch to comply with
the protective structure.
*2 Leave the GOT on for more than 10 minutes before replacing the battery.
Replace the battery within five minutes.
Use GT11-50BAT for the battery. Incorrect handling may cause the battery to explode.
Dispose of the battery as industrial waste.
*3 Use the copper wires for the wires to be connected to the power supply terminal.
5 PART NAMES AND SETTINGS
52
Description
SD/RD LED ON: Data sent or received
SD/RD LED OFF: Data not sent or received
SPEED LED ON: Communicating at 100 Mbps
SPEED LED OFF: Communicating at 10 Mbps or disconnected
For communicating with a controller (connector shape: D-sub 9-pin (female), M2.6 metric screw
thread)
For the pin layout of the connector, refer to the following.
GOT2000 Series Connection Manual (Mitsubishi Electric Products) For GT Works3 Version1
For communicating with a controller (connector shape: D-sub 9-pin (male), #4-40UNC inch screw
thread)
For the pin layout of the connector, refer to the following.
GOT2000 Series Connection Manual (Mitsubishi Electric Products) For GT Works3 Version1
For outputting sounds (applicable plug: Φ3.5 stereo mini-plug (3-prong))
*2*3
mark: