Fabricating A Connection Cable - Mitsubishi Electric GOT SIMPLE Series Operation Manual

Fabricating a connection cable

Fabricate the cables used for the GOT by the methods as shown in this section.
The fabrication requires a ferrite core, cable clamp, and cable shielding materials.
The following products have passed the Mitsubishi Electric EMC Directive compliance test.
ZCAT3035-1330 ferrite core (TDK Corporation)
AD75CK-type cable clamp (Mitsubishi Electric Corporation)
Zipper tubing SHNJ type (Zippertubing (Japan),Ltd)
Ethernet connection
■Ethernet cable
Strip off the sheath at both ends of the cable as shown in the figure below to expose braided shield for grounding.
The braided shield sections are used for grounding with a cable clamp.
Page 63 Grounding a cable
Connecting to the Ethernet interface of the GOT
GOT side
230 or less
(9.06)
Direct CPU connection (serial)
■RS-232 cable and RS-422 cable
Install a ferrite core to the cable in the positions as shown in the figure below.
GOT side
100 or less
(3.94)
Serial communication connection
■RS-232 cable and RS-422 cable
Strip off the sheath at both ends of the cable as shown in the figure below to expose braided shield sections for grounding.
The braided shield sections are used for grounding with a cable clamp.
Page 63 Grounding a cable
GOT side
230
or less
(9.06)
6 EMC DIRECTIVE
60
6.2 EMC Directive Requirements
40
40
(1.57)
(1.57)
Ferrite Core
(ZCAT3035-1330)
40
(1.57)
PLC/personal computer side
400 or less
(15.75)
PLC side
PLC CPU side
230
40 or less
(1.57) (9.06)
Unit: mm (inch)
100 or less
(3.94)
Unit : mm (inch)
Unit: mm (inch)