Removing The Sd Card - Mitsubishi Electric GOT SIMPLE Series Operation Manual

Removing the SD Card

Do not remove the SD card from drive A while the SD card is being accessed by the GOT, or the
GOT may stop processing for about 20 seconds.
The GOT cannot be operated during this period. The functions that run in the background including a
screen updating, alarm, logging, scripts, and others are also interrupted.
This stop affects the system operation, causing an accident.
Check that the SD card access LED is off before removing the SD card.
Do not remove the data storage from the GOT while the data storage is being accessed by the GOT,
or the data storage and files may be damaged.
To remove the data storage from the GOT, check that the access to the data storage in SD card
access LED, the system signal, and others is not performed.
Turning off the GOT while it accesses the SD card results in damage to the SD card and files.
When removing the SD card from the GOT, make sure to support the SD card by hand as it may pop
out.
Failure to do so may cause the SD card to drop from the GOT, resulting in a failure or break.
To remove the data storage from the GOT, follow the procedure for removal on the utility screen of
the GOT. After the successful completion dialog is displayed, remove the data storage by hand
carefully.
Failure to do so may cause the data storage to drop from the GOT, resulting in a failure or break.
GS2512-WXTBD
The following shows the procedure for removing the SD card.
1.
Open the SD card cover as shown below.
7 INSTALLATION AND REMOVAL
78
7.7 Installing and Removing the SD Card
WARNING
CAUTION