Mitsubishi Electric GOT SIMPLE Series Operation Manual page 314

When installing or removing an SD card
Always set [Permissions] on the GOT. For details, refer to the following.
Page 306 SD Card Access
Error display
When copying is not available between the GOT and the SD card, check the following contents according to the GOT error
display.
Error message
SD card is not attached.
GOT type is unmatch.
Write protection switch ON.
Available package data is notexisted.
27 CONTROL OF VARIOUS DATA (DATA CONTROL)
312
27.7 Data Copy
Touch
Remedy
Install an SD card to the GOT.
The model set for the data in the SD card does not match with that of the copy target GOT.
Use the same model data as that of the copy target GOT.
The write protection switch of the SD card is ON.
Turn off the write protection switch.
There is no data to be a copy target in the copy source.
Store the data to be copied in the copy source and copy it again.
6.
Copy is completed. If the [×] button is touched, the
screen is closed. If an error occurs during copy, an error
message appears. For details of error messages, refer
to the following.
Page 312 Error display
When only the project data was copied to the GOT, touch the
[ESC] button to restart the GOT and display the user-created
screen.
When the basic system application was copied, the GOT will
automatically start up and display the user-created screen.
(If the project data does not exist, a message appears to
notify that the project data does not exist.)