Table of Contents
Advertisement
28.3
FX3U-ENET-ADP Communication Setting Function
In GX Works2, the communication set value of the FX3U-ENET-ADP stored in the CPU can be changed.
This function is not available when the communication set value of the FX3U-ENET-ADP is not set in advance in the CPU.
Communication setting in the CPU
In GX Works2, set in advance the communication set value of the FX3U-ENET-ADP to the CPU.
For the details of the communication setting, refer to the following.
FX3U-ENET-ADP User's manual
Specifications
System configuration
This section describes the system configuration of the FX3U-ENET-ADP communication setting function.
For the setting method in each connection form, used communication unit/cable and cautions on connection form, refer to the
following manual.
GOT2000 Series Connection Manual For GT Works3 Version1
■Required basic system application
Operating system
Basic system application
Communication driver
■Connection type
( : Applicable, : Partly restricted, : Inapplicable)
Function
Name
FX3U-ENET-ADP communication
setting function
■Communication setting items
The table below shows the communication setting items and setting range.
Communication setting items
IP address
*1
Subnet mask pattern
*1
Default router IP address
*1 Set the value "0.0.0.0" when not using the subnet mask pattern and default router IP address.
MELSEC-FX
Description
The communication set value of the FX3U-ENET-ADP
stored in the CPU can be changed.
Setting range
0.0.0.1 to 223.255.255.254
192.0.0.0 to 255.255.255.252
0.0.0.1 to 223.255.255.254
Version
-
-
Connection type between GOT and controller
Direct CPU
connection
(serial)
Remark
If a value outside the setting range is entered, the error message "SET
NUMBER IS INCORRECT." appears.
28 GOT SELF CHECK (DEBUG)
28.3 FX3U-ENET-ADP Communication Setting Function
GOT multi-drop connection
377
28
Advertisement
Table of Contents
Troubleshooting
