Table of Contents
Advertisement
4 - 18
2
Fig. 23
Air suction hose
To support arm serial number 0050
•
Remove the covers of the basic system unit and the shock wave head.
•
Remove the shock wave head (refer to the corresponding section).
•
Pull the temperature sensor (T/Fig. 18) in the shock wave head support somewhat
forward and then push it back through to the side.
•
Secure the spiral spring to the sensor supply cable (x/Fig. 19) approx. 4 cm behind the
temperature sensor with adhesive tape (KB/Fig. 19) to keep it from slipping back.
•
Remove the white teflon plate (Tp/Fig. 18) by removing the screws.
•
Push the high-voltage connector (W/Fig. 20) slightly to the side for better access to the
water supply (Fig. 20).
•
Now pull the water supply (W/Fig. 20) with the center air suction hose slightly forward in
the shock wave head support and then push it back through to the side.
•
Remove the front bracket connection (F/Fig. 25) on the water supply by removing the
screws.
•
Remove the front part (E/Fig. 25) of the water supply by removing the screws.
•
Disconnect the old water hose.
•
Install the new water hose and secure it with the appropriate hardware.
•
Remove the front part (E/Fig. 25) of the water supply by removing the screws.
•
Puncture the tubing with a needle (app. 1 mm) twice at this point (<-/Fig. 25).
•
Insulate the bracket connection of the water supply (F/Fig. 25) just removed, i.e. attach
new teflon insulation tape with the screws; when doing this do not block the opening to
the pressure sensor.
MODULARIS Uro Plus
LITHOSTAR MODULARIS
5
4
Fig. 24
SPL1-130.840.02
Page 18 of 34
Rev. 03
04.05
CS PS 24
6
3
4
4
Siemens AG
Medical Solutions
Advertisement
Table of Contents
