Table of Contents
Advertisement
4 - 4
•
Open valve Y8(Fig. 10, 11),
i.e. switch the Y8 lever from horizontal = closed to vertical = open.
•
Switch the system on.
•
Set service switch S2 on board D3 to position 2 (service on).
•
Select "service" on the control unit and then "cooling unit".
•
Activate the corresponding key for "empty" on the control unit until no more water flows
out.
•
Adjust service switch S2 on board D3 to position 1 (service off).
•
Switch the system off.
•
Remove the 2 Allen screws (U/Fig. 4) underneath the shock wave head.
•
Remove the screw (SL/Fig. 7) with the protective conductor on the shock wave head.
•
Wait at least 10 minutes after switching the system off. Then push the high-voltage
connector downward, until the openings (O/Fig. 7) are free.
•
Loosen the Allen screws in the openings (O/Fig. 7) but do not remove them.
•
Disconnect all the water hoses at both interfaces of the shock wave head.
•
Remove the shock wave head toward the front.
NOTICE
MODULARIS Uro Plus
There may be water remaining in the shock wave head.
SPL1-130.840.02
Rev. 03
04.05
LITHOSTAR MODULARIS
Page 4 of 34
CS PS 24
Siemens AG
Medical Solutions
Advertisement
Table of Contents
