Siemens MODULARIS Uro Plus Service Instructions Manual page 64

4 - 24
SIREMOBIL Iso-C switch
Fig. 28
System con- 1 LITHOSTAR MODULARIS
figuration and
n = several 1 SIREMOBIL Iso-C
To support arm S0050
Adjustment of iso-center on the shock
wave head; refer to chapter "Iso-cen-
ter with X-ray - to support arm serial
Remove doc-
number 0050."
cking plate
From support arm S0051
Adjustment of iso-center on the
SIREMOBIL Iso-C; refer to chapter
"Iso-center with X-ray - from support
arm serial number 0051."
NOTICE
MODULARIS Uro Plus
Damage of docking plate.
The lift switch-off in the SIREMOBIL Iso-C may not switch off if the
floor is not level. If this is the case, make use of the additional
steering castors (see also Operating Instructions).
SPL1-130.840.02
Rev. 03 04.05
LITHOSTAR MODULARIS
7
S2
S1
Fig. 29
1 LITHOSTAR MODULARIS
and
n SIREMOBIL Iso-C
It is important to follow this workflow to
avoid having to readjust the iso-center on all
SIREMOBILE!
•
Prior to removing the docking plate, view the
iso-center (the three C-arm positions) and if
possible, save it or make a hardcopy.
•
Remove the docking plate (mark the position
on the SIREMOBIL Iso-C).
•
Perform the necessary work on the
SIREMOBIL Iso-C.
•
Tighten the docking plate back into place.
•
Check iso-center; the setting must be
identical to how it was prior to removing the
docking plate.
If an adjustment is necessary, it must be made
via the iso-center setting on the SIREMOBIL
Iso-C; refer to chapter "Iso-center with X-ray -
form support arm serial number 0051."
Page 24 of 34
CS PS 24
Siemens AG
Medical Solutions