Tools And Measurement Devices Required; Auxiliary Devices And Documents Required - Siemens MODULARIS Uro Plus Service Instructions Manual

Hide thumbs Also See for MODULARIS Uro Plus:

page of 110

/ 110
Contents
Table of Contents
Bookmarks

Table of Contents

1 - 2

Initial measured value

The equivalent leakage current measurement was performed at the factory and the value

measured was entered in test protocol 1. The measurement was made at the line voltage

and line frequency indicated in test protocol 1.

If the line voltage or the line frequency on-site deviates from the information indicated

upon delivery of the Modularis Uro Plus, the values given are invalid. The values should

be marked invalid (crossed out with the comment "invalid values" and the service engi-

neer should sign and date this copy).

In this case, the equivalent leakage current must be measured again. The value may not

exceed 1 mA according to DIN VDE 0751, Part 1.

The initial value measured must be documented.

Repeat measurements

When service or repair work is performed on the primary power supply circuit (e.g. repairs

to the power-on circuit), the equivalent leakage current test must be repeated. The values

measured in the subsequent test may not exceed the threshold value of 1 mA as specified

in VDE 0751, Part 1. In addition, they may not exceed the initial measured value by more

than 50%. If the value exceeds this threshold, the system must be repaired. The value

measured must be documented.