Table of Contents
Advertisement
4 - 12
Hose pump head in the coupling circuit
Removing the hose pump head
•
Remove the system cover and the cover of the shock wave head.
•
Empty the coupling circuit (refer to the section "Emptying the coupling circuit").
•
Switch the system off.
•
Remove the safety latch on the hose pump head.
•
Press the black lock (1/Fig. 10/11) upward or downward and remove the hose pump
head from the drive.
•
Open the 2 hose clamps and remove the hoses.
•
Remove the hose pump head.
Installing the hose pump head
•
Place the hose pump head on the drive shaft and lock into place.
•
Reconnect the 2 hoses with the hose clamps.
Ensure that the hoses are the correct length, i.e. cut them to the same length as the old
hoses.
•
Fill the coupling circuit (refer to "Filling the coupling circuit").
Hose pump head in the cooling circuit
Removing the hose pump head
•
Switch the system off.
•
Open the system cover.
•
Empty the cooling circuit (refer to the section "Emptying the cooling circuit").
•
Remove the safety latch on the hose pump head.
•
Press the black lock (1/Fig. 10) downward or upward and remove the hose pump head
from the drive.
•
Open the 2 hose clamps and disconnect the hoses.
•
Remove the hose pump head.
Installing the hose pump head
•
Place the hose pump head on the drive shaft and lock into position.
•
Reconnect the 2 hoses with the hose clamps.
Ensure that the hoses are the correct length, i.e. cut them to the same length as the old
hoses.
•
Fill the cooling circuit (refer to the section "Filling the cooling circuit").
MODULARIS Uro Plus
LITHOSTAR MODULARIS
SPL1-130.840.02
Page 12 of 34
Rev. 03
04.05
CS PS 24
4
4
4
4
4
4
Siemens AG
Medical Solutions
Advertisement
Table of Contents
