Adding An Airway To The Active Flight Plan; Adding An Airway To A Stored Flight Plan - Garmin G1000 NXi Reference Manual

Flight Management
4) With 'OK' highlighted, press the ENT Key. To cancel the request, press the
CLR Key, or highlight 'Cancel' and press the ENT Key.
5) To change the waypoint back to a fly-by waypoint, highlight the desired
waypoint. Press the MENU Key, highlight 'Set Fly-By Waypoint', and press
the ENT Key. The 'Set <waypoint> to be a fly-by waypoint?' Window is
displayed. With 'OK' highlighted, press the ENT Key.

ADDING AN AIRWAY TO THE ACTIVE FLIGHT PLAN

1) Press the FPL Key.
2) Press the FMS Knob to activate the cursor (not required on the PFD).
3) Turn the large FMS Knob to move the cursor below the airway entry
waypoint for the insertion point. If there is no valid airway entry waypoint
in the flight plan, one must be entered first.
4) Turn the small FMS Knob for the MFD one click clockwise and press the
LD AIRWY Softkey, or press the MENU Key for the and select "Load
Airway"(PFD or MFD). The LD AIRWY Softkey or the "Load Airway" menu
item is available only when a valid airway entry waypoint has already been
entered in the flight plan.
5) Turn the FMS Knob to highlight the desired airway from the list, and press
the ENT Key. Low altitude airways are shown first in the list, followed by
"all" altitude airways, and then high altitude airways.
6) Turn the FMS Knob to highlight the desired airway exit point from the list, and press the
ENT Key. 'Load?' is highlighted.
7) Press the ENT Key. The system returns to editing the flight plan with the
new airway inserted.

ADDING AN AIRWAY TO A STORED FLIGHT PLAN

1) On the 'FPL - Flight Plan Catalog' Page, press the FMS Knob to activate the
cursor.
2) Highlight the desired flight plan.
3) Press the EDIT Softkey; or press the ENT Key, turn the large FMS Knob
clockwise to highlight "EDIT" and press the ENT Key. The 'FPL - Stored
Flight Plan' Page is displayed.
62
Garmin G1000 NXi Cockpit Reference Guide for the Cessna NAV III
190-02178-02 Rev. A