Garmin G1000 NXi Reference Manual page 250

Appendix
e) Press the ENT Key or the right-most softkey on MFD display to
acknowledge the startup screen.
f) Turn the large FMS Knob and select Aux
g) Turn the small FMS Knob and select Databases.
h) Verify that the standby databases transferred and are now in the Active
column.
21) For additional information on each database, press and then turn the FMS
Knob to select the database, and then press the Details Softkey. Press the
ENT Key or the FMS Knob to exit.
Or:
Press the Menu Key and select 'Details' using the small FMS Knob and press
the ENT Key. Press the ENT Key or the FMS Knob to exit.
22) To view database information for an individual display:
a) Turn the large FMS Knob and select Aux.
b) Turn the small FMS Knob and select System Status.
c) Press the Display Database Selection Softkey (MFD1 DB, PFD1 DB, PFD2
DB) to show database information for each display. Use the small FMS
Knob to scroll through the database information. Press the ENT Key or
the FMS Knob to exit.
Updating Databases from the 'Aux - Databases' page:
NOTE: The system will only provide a WiFi connection if new databases have
been detected for download on Garmin Pilot via a valid Bluetooth connection.
If there are no database updates required the system will not provide a WiFi
signal.
NOTE: If the mobile device has previously connected to the FS510, and is
not connected to another WiFi source, the mobile device should connect
automatically to the FS510. If the mobile device is connected to another WiFi
source (i.e. hangar wifi), then the FS510 will not connect automatically.
1) Insert the Wireless Transceiver SD Card in the bottom slot of the MFD if not
already inserted.
2) Turn the system ON.
3) Press the ENT Key or the right-most softkey on MFD display to
acknowledge the startup screen.
224
Garmin G1000 NXi Cockpit Reference Guide for the Cessna NAV III
.
190-02178-02 Rev. A