Creating (Or Editing) A Flight Plan In Pan Mode - Garmin GTN 625 Reference Manual

Creating (or Editing) a Flight Plan in Pan Mode

NOTE: It is not possible to graphically add an intermediate waypoint between
the current position and a Direct-To waypoint unless that waypoint is in the
flight plan. Garmin recommends deleting any flight plan prior to graphically
editing a Direct-To waypoint.
NOTE: When graphically editing the active flight plan leg, the active leg
course and TO waypoint will be added to the flight plan as a Direct-To.
While in Pan Mode, touch the Graphically Edit FPL key to add/remove
waypoints and/or alter a course line in an existing flight plan. You can also
enter or edit an existing flight plan by touching the Flight Plan key on the
home page. See the "Flight Plan" section of this guide.
On the Map page, enter Pan Mode by touching the screen. Touch the
Graphically Edit FPL key. Touch any waypoint that you want to be part of
your flight plan. You also can touch and drag a flight plan line to a waypoint.
Should you make an error, touch the Undo key. The Undo key will reverse
up to the last nine consecutive edits. When finished, touch the Done key to
save your changes. Touch Cancel to leave the screen without making any
changes to the flight plan.
Touch to leave
the page without
changes to the
flight plan.
10
Undo Key
Flight Plan on Map Page
GTN 625/635/650 Cockpit Reference Guide
Touch to confirm the
entries into the flight plan.
190-01004-04 Rev. N