Garmin G1000 NXi Reference Manual page 232

Annunciations & Alerts
Message
VNV – Unavailable. Unsupported leg
type in flight plan.
WPT ARRIVAL – Arriving at waypoint
-[xxxx]
XPDR1 ADS-B 1090 – Datalinik:
ADS-B 1090 receiver has failed.
XPDR1 ADS-B FAIL – Transponder:
XPDR1 is unable to transmit ADS-B
messages.
XPDR1 ADS-B NO POS – Transponder:
ADS-B is not transmitting position.
XPDR1 ADS-B TRFC – Transponder:
ADS-B traffic has failed
XPDR1 ADS-B UAT – Datalink: ADS-B
in UAT receiver has failed.
XPDR1 CONFIG – XPDR1 config error.
Config service req'd.
XPDR1 CSA FAIL – Traffic: ADS-B In
traffic alerting has failed.
206
Garmin G1000 NXi Cockpit Reference Guide for the Cessna NAV III
Comments
The lateral flight plan contains a procedure
turn, vector, or other unsupported leg type prior
to the active vertical waypoint. This prevents
vertical guidance to the active vertical waypoint.
Arriving at waypoint [xxxx], where [xxxx] is the
waypoint name.
A failure has been detected in the 1090
receiver.
ADS-B is inoperative. The transponder may
not be receiving a valid GPS position. Other
transponder functions may be available. Service
when possible.
The transponder is not able to receive position
information.
The Transponder is incapable of processing
traffic information.
A failure has been detected in the UAT receiver.
The transponder configuration settings do not
match those of backup configuration memory.
The system should be serviced.
ADS-B Conflict Situational Awareness (CSA) is
unavailable.
190-02178-02 Rev. A