Garmin G1000 NXi Reference Manual page 247

Press the
Knob. Press the
indicating the standby database will become active.
d) Remove and reapply power to the system.
e) Press the
acknowledge the startup screen.
f) Turn the large
g) Turn the small
h) Verify the standby databases transferred and are now in the Active
column.
18) For additional information on each database, push and then turn the
Knob to select the database, and then press the
ENT
the Key or push the
Or:
Press the
press the
19) To view database information for an individual display:
a) Turn the large
b) Turn the small
c) Press the Display Database Selection Softkey (MFD1 DB, PFD1 DB) to
show database information for each display. Use the small
to scroll through the database information. Press the
FMS
Knob to exit.
Updating Databases Using the Wireless Transceiver
In order to load databases through Garmin Pilot and the Wireless Transceiver (also
known as Flight Stream 510 or FS510), the Wireless Transceiver must be enabled
on the system and inserted in the bottom SD slot of the MFD. A mobile device with
Garmin Pilot must be paired with the Wireless Transceiver over Wireless (refer to the
Additional Features section). When there is at least one paired device available to
connect, the Wireless Transceiver will automatically connect to the system' s preferred
mobile device. The preferred device can be selected on the 'Aux - Databases' Page
from a menu list of paired devices.
190-02178-02 Rev. A
MENU
Key and select 'Swap Stby/Actv' using the small
ENT
Key. A cyan double-sided arrow will appear
ENT
Key or the right-most softkey on MFD display to
FMS
Knob and select Aux
FMS
Knob and select Databases.
FMS
Knob to exit.
MENU
Key and select 'Details' using the small
ENT
Key. Press the
FMS
Knob and select Aux.
FMS
Knob and select System Status.
Garmin G1000 NXi Cockpit Reference Guide for the Cessna NAV III
.
Details
ENT
Key or push the
Appendix
FMS
FMS
Softkey. Press
FMS
Knob and
FMS
Knob to exit.
FMS
Knob
ENT
Key or the
221